I thought it was time I created an improved tutorial for my paper cone wreaths. You can find my original tutorial made from vintage sheet music here. These paper wreaths get a lot of attention on my instagram account and they’re not that hard to make. I was delighted last week when I found an old atlas from 1965 for $2 in an op shop. The colours that adorned the pages were so beautiful that I knew it would be my prettiest wreath yet. Of course, you can use whatever paper you prefer – sheet music, golden books, a dictionary or even Christmas paper would all work well. Here’s what you’ll need –
- double sided tape
- hot glue gun and sticks
- lacquer suitable for paper
Step 1 – cut up your paper. I divided the atlas pages into quarters, measuring 11 x 14cm, so this will be quite a small wreath, but you can use whatever size you prefer. The bigger the page, the bigger the wreath. Step 2 – stick a piece of double sided tape across the bottom of the paper. You can see in the picture that it doesn’t need to go all the way across, but it’s important that it covers the far right corner of the paper.Step 3 – take your paper and bring the top lefthand corner across the front. Then wrap the top righthand corner around and stick in place to form a cone. Step 4 – fold under about a 1/4 of the bottom of the cone and then staple it into place.Step 5 – cut off the excess paper. This reduces bulk when you glue your cones together.Step 6 – make around 60-70 cones. The number of cones needed depends on the size of your wreath.
Step 7 – cut a circle out of cardboard. My circle measures 14cm across.Step 8 – using a hot glue gun, start sticking your cones to the circle of cardboard. I like to place cones marking four quarters and then fill in the gaps with equal numbers of cones. This helps to create a uniform and symmetrical wreath. In the picture below you can see the first round completed.Step 9 – continue to attach your paper cones round by round. The number of rounds depends on the size of your wreath.
Step 10 – once you reach the centre of the wreath, you may find it tricky to fit the paper cones in place. Don’t be afraid to cut more length off your cones to help them to fit into place. Ta da! All finished.
Step 11 – I like to spray my completed wreaths with a couple of coats of lacquer to make the paper more durable.